My Man loves to collect old bottles. He finds most of them when he is out surveying around old homesteads. He somehow knows exactly where to look for the trash pile and heads straight for it first thing.
He has found old Royal Crown bottles, Nehi bottles, Red Rock bottles, many Milk of Magnesia bottles in different sizes, all sizes of Mason jars (the blue ones with the zinc tops). We have over 40 old bottles and still collecting more.
So, where do we put them all, you ask. Good question.
MM has built some shelves for them and I’m going to show you how he did it.
- A 1 x 4 board cut to the length you want. For over the door we used a full 6 foot board.
- Molding at least an 2 inches wide
- Paint or stain
- Finishing nails and hammer
- Screws and a screw driver
- Table saw (or have the home improvement store cut it for you. This is usually done for free. You need to know your measurements.)
Putting It All Together
The shelves you see in the pictures were made to go above door frames, but we used to have the on three smaller shelves that he made the exact same way, but we had them on the wall above our sofa. So…
Cut the board to length and sand.
Cut the molding the length of the front and sides of the board. Where the front and the side edge meet needs to be cut at a 45 degree angle.
We painted the boards before we put it all together.
Nail the molding to the sides of the board, then the front, keeping the bottom of the molding flush with the bottom of the board. (That’s what the pen is supposed to be showing you.) TIP: MM used finishing nails and before he nailed them he “dulled” the nail by tapping them with a hammer first. This helps to keep the molding from splitting.
The top of the molding is rises above the top of the board. This gives you a “bumper” to keep the bottles from falling off the shelf. Normal, everyday vibrations cause the bottles to move. Slowly, but surely.
To make the braces decide how tall you need it to be. Three of the side need to be straight edges. The front side can have some sort of design, if you want. MM got the curves by using cans and bottles to get the curves. He just eyeballed it. Oh, you can make the braces out of left over wood from you shelves or any other scraps you may have. If you don’t have scrapes, you’ll need to get another piece of wood. And… MM used a band saw to cut this.
To hang the shelf, MM drilled holes on the backs of the brace. They are just a touch bigger than the screws we used to hang the shelf.
Decide where you want to hang the shelf and hang it using screws in the wall. Make sure your know where you want them to go and how much weight you may put on them. You may need to attach them to the studs.
MM made this shelf by attaching a board to a curtain rod that came with the braces.
He has made several kinds of shelves and soon I will do a post on them.
I love the way the bottles look over the doors. They add texture and color. Of course, you could put plates or pictures or anything else on them.
Now he is ready for the next project on my list.